Esembly Wipe Up Wash & Foamer Kit: Setup and Use Guide
By Best Organic Cloth Diaper System - Esembly Baby | Published: 2026-11-02
Category: How-to Guides
Learn how to mix and use the Esembly Wipe Up Wash & Foamer Kit for gentle, no-rinse cloth wipe changes. Step-by-step setup and practical tips.
Quick answer
To set up the Esembly Wipe Up Wash & Foamer Kit, mix the pre-measured concentrate with water in the foamer bottle according to the instructions, then pump foam onto a cloth wipe for no-rinse diaper changes. Always test the solution on a small area first and store it properly between uses.
Why the foamer bottle makes a difference
The pre-measured foamer bottle takes the guesswork out of mixing. Instead of diluting concentrate by eye, you add the entire contents of one concentrate packet to the bottle, fill with water to the marked line, and shake. This consistent ratio helps avoid a solution that is too weak to clean or too strong for sensitive skin.
A foamer bottle also uses less liquid per wipe than a spray or pour bottle because the pump aerates the solution into a dense foam that stays on the cloth wipe. That means one kit lasts longer and produces less waste.
When to choose a no-rinse foaming solution
A no-rinse foaming wipe solution is convenient for diaper changes when you do not have access to a sink, such as overnight changes or outings. It cleans and moisturizes without requiring a separate rinsing step, which can be helpful for delicate skin.
However, if your baby has very sensitive skin or a diaper rash, consult your pediatrician before using any new wipe solution. Also, if you prefer a traditional wet wipe that you rinse or if you use disposable wipes, this kit is not necessary.
Step-by-step setup and use
- Unpack and check contents: Remove the foamer bottle and concentrate from the kit. Confirm you have the bottle, the pump top, and the concentrate. Wash the bottle and pump with warm soapy water before first use, then rinse well. Skipping the initial wash can leave manufacturing residue that affects foam quality.
- Mix the concentrate: Pour the entire concentrate into the foamer bottle. Add water up to the fill line indicated on the bottle (use distilled or filtered water if your tap water is hard). Screw on the pump top securely. Do not overfill past the line; leaving room for air is essential for foaming.
- Shake gently to combine: Shake the bottle gently for about 10 seconds. Do not shake vigorously, which can create excess bubbles that interfere with the pump mechanism. If the solution looks separated, a gentle swirl is enough; vigorous shaking wastes solution.
- Prime the pump: Press the pump several times over a sink until foam emerges. The first few pumps may release only liquid as the pump primes. Priming over a sink avoids mess and ensures consistent foam from the first use.
- Apply to cloth wipe: Pump one or two doses of foam onto a clean cloth wipe (such as Esembly Wipe Ups). Use the wipe to gently clean your baby's bottom during a diaper change. No rinsing required. Use a fresh wipe for each change; do not dip used wipes back into the bottle.
- Store and maintain: Replace the cap after use and store the bottle at room temperature, away from direct sunlight. Discard any leftover solution after the period recommended in the kit instructions (typically a few weeks). Rinse the pump occasionally to prevent clogging. Label the bottle with the mixing date so you know when to make a fresh batch.
Product facts
- Wipe Up Wash & Foamer Kit: The Wipe Up Wash & Foamer Kit includes a pre-measured foamer bottle and a no-rinse cleanser made with organic castile soap and hydrating organic oils. The pre-measured bottle simplifies mixing, while the castile soap and oils clean and moisturize during changes without rinsing.
Wipe Up Wash & Foamer Kit
